K. W. McAvoy & Son, Inc.

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

An employee was shoveling excess material (spillage) that consisted of dry mix, sand, aggregate and cement. As he was shoveling, some material blew back in his face and around his safety glasses. He got a piece of metal in his left eye that required surgery. The employee was hospitalized.

An employee was feeding boards into an edger. They fed a board in and then adjusted the blade for a second board that was wider. When they fed the second board into the edger, it hit the first board and kicked back, striking the employee in the chest. They sustained injuries including a spine fracture, an injured pancreas, as well as potential injuries to their spleen, liver, and intestine. The employee was hospitalized and required surgery.

An employee was helping an operator to pull a cable off a winch. The operator pulled in the line when it hooked some tree brush. The brush then whipped around and struck the employee's arm, resulting in a broken arm.

A co-worker was adjusting an overhead bracket with an impact wrench when the tool flew out of their hand and struck the injured employee in the face. The injured employee sustained an injury to their left eye.

An employee was operating a saw when their right hand contacted the blade(s), resulting in amputation of four fingers and a partial thumb amputation.

An employee was using a telehandler to move pallets of pellets from a pod. The employee exited the telehandler to pick up a sacrificial pallet that is placed under the bottom layer of pallets. When the employee turned to pull the pallet away, the top two tiers of the pod fell on him. The employee sustained a fractured ankle, three fractured ribs, and fractured vertebrae.

An employee was preparing to replace a belt on a fan drive assembly. He went to manually stop the fan and was caught by the belt. His hand was pulled into the machine and his left little fingertip was amputated.

An employee was cutting remanufactured lumber with a chainsaw when a board fell and struck his left hand, causing his left hand to move off the chainsaw. While he was moving his hand back, the chainsaw kicked back and lacerated the top of his left hand. The employee was hospitalized.

An employee was building crates using a nail gun. The gun shot two nails into his upper right thigh.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.