LINDSAY MANUFACTURING

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

During a break, an employee was engaged in a conversation with a customer. They were standing approximately 7 feet in front of a combine header that was attached to a payloader but also set on jack stands for support. The header dislodged from the payloader, slid forward along with its support stand, and struck both the employee and the customer. The employee was hospitalized with fractures to thoracic and lumbar vertebrae, a fractured rib, and a partially deflated lung. The customer also sustained injury.

An employee was replacing a manure belt in an egg producing poultry house. He was using a mechanical roller and a steel cable to pull (remove) the old manure belt. The employee's ring and little fingertips were pinched between the roller and the cable resulting in partial amputations above the top knuckle.

An employee was walking past a cow barn when he slipped on a wet floor mat and fell. The employee sustained torn ligaments and his quadriceps were torn from the bone on both legs.

An employee was working on a bale accumulator attached to a tractor. While he was making adjustments, the accumulator activated. The bar of the accumulator struck him and dragged him to the side, and his right leg was run over. He suffered a broken femur.

An employee tripped on a piece of wood and fell onto the rough edge of a metal tank under fabrication. The employee was hospitalized with a laceration on his hand.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.