Fall through surface or existing opening 6 to 10 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Duncan Machinery Movers, Inc., 26999 Old Madison Hwy 20, MADISON, ALABAMA 35756
on — Fractures, affecting the upper and lower limb(s).
Watch Duncan Machinery Movers, Inc. — freeGet an email when a new federal OSHA severe-injury report for Duncan Machinery Movers, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was installing round duct in a clean room ceiling. When he placed his knees on an access hatch door, the latches gave way and the employee fell approximately 10 feet through the opening to the metal floor below. The employee sustained fractured legs and a fractured left shoulder and was hospitalized.
HospitalizedUpper and lower limb(s)Existing floor opening
An employee was laying out a 2-by-4 for railing on a second floor. The employee fell backward through an opening and landed on a concrete floor about 9.5 feet below, suffering broken vertebrae.
An employee was a spotter for a trap door that was being tested prior to a show. The trap door activated and the employee fell approximately 8 feet onto stunt mats that were covering the floor below. The employee sustained a fractured right shoulder, a dislocated right ankle, and a sprained left ankle.
An employee was moving a robot when they fell approximately 9 feet through a catwalk hole and landed on the floor. The employee sustained a head injury.
An employee was working in the attic of a modular home. As he was attaching a 2x4, the employee fell 9 feet through the ceiling to the ground. He sustained a fracture near the spinal cord.
More severe injuries in this industry (NAICS 238290)
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.
An employee was assisting with cutting a vertical steel pile. A 16-foot by 9-inch section of pile dropped to the side and bounced off a previously cut pile and toward the employee. The employee was struck in the torso and leg, causing his knee to dislocate from his femur. The employee was hospitalized.
On July 30, 2025, an employee was utilizing a circular saw to cut plastic into strips that would be used as shims. The blade of the saw amputated his left little finger to the second knuckle.
An employee was working on the ingot loader of a aluminum processing machine and noticed a pin was not installed. The employee reached to retrieve the pin and the machine activated for a functions test. The machine closed on the employee's hand, resulting in a hand injury requiring hospitalization.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.