Struck by falling object or equipment, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Louisiana Pacific Corporation, 1199 County Road 201, CARTHAGE, TEXAS 75633
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was cleaning out a wood burner. A falling clump of wood ash struck his right hand in the airlock, causing the amputation of the ring fingertip against the airlock fin and the chute's frame.
An employee was holding the door for a co-worker when the tip of his right thumb was pinched and severed between the jamb and the door edge. The employee sustained an amputation of the distal thumb tip.
On January 20, 2025, an employee was walking between buildings when they slipped on ice and fell. The employee was hospitalized with fractures to their left tibia and fibula.
The injured employee was on the ground level receiving an OSB board from a co-worker who was on a 10-foot-high catwalk. The board was 4 feet by 25 feet and weighed approximately 270 pounds. As it was being slid down a handrail by a crew of three employees, the board went over the rail and landed on the injured employee's left foot, resulting in a fracture.
An employee was troubleshooting an airlock screw. The airlock's rotating blade struck the employee's right index, middle, and ring fingertips, resulting in partial amputations.
An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.
An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.
An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.
An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.
An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.
While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.