American Axle & Manufacturing Holdings, Inc.

An employee was walking back to her workstation. A forklift reversed a short distance, then completed a U-turn and struck her, running over her lower extremities. She was hospitalized with a broken ankle.

An employee was training on a jockey truck. Upon stepping out of the truck, the employee was struck by a rubber tire gantry crane, resulting in amputations of the right leg above the knee and left leg below the knee.

An employee was standing at the rear of a double pallet jack. Another double jack approached, and the employee's lower leg was caught between the two pieces of equipment. He suffered a broken tibia and fibula.

An employee was unloading large material bags on a loading dock. A forklift tine pinned the employee's foot against a pallet, causing the employee to fall and suffer a broken ankle.

An employee was pushing a container when they were struck by a forklift. The employee sustained a left leg fracture.

An employee was riding on the side of a forklift. He stepped off the forklift and was struck by the back end of the forklift as it turned to the right. The forklift's back tire ran over his leg, resulting in an amputation. The employee was hospitalized.

An employee was loading a nozzle, weighing approximately 500 pounds, onto a positioner. The stainless steel nozzle slipped off the positioner and struck the employee's right leg. The employee's right tibia was fractured and their left knee was bruised.

An employee was preparing a hammer and dies for operation. The ram prop was inserted in the hammer to secure the ram. While the employee went to apply grease to the die shim in the hammer, the ram moved downward. The motion dislodged the prop, causing the ram to drop and crush the employee's right hand and forearm. The employee sustained amputations to their hand and arm and was hospitalized.

An employee was doing a tool changeover on a table mill and changing the mandrel. His hands were on both wrenches with his right thumb was between the two wrenches as he worked to unlock the mandrel. The wrenches came together, crushing his thumb. The employee was hospitalized with a partial amputation of the thumb.

An employee was helping to remove tooling that was stuck in a forging press (a full-revolution mechanical power press). The press cycled, resulting in partial amputations to two fingers on his left hand.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.