Thomas Bandsaw Mills, OEM

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

On May 9, 2025, an employee was using an air hose to clear debris from the courtyard area when she slipped and fell. The employee was hospitalized with closed fractures to her left fibula, tibia, and medial malleolus.

On April 24, 2025, an employee was opening a cylinder door on a hydraulic bridge to remove lumber when their left middle finger was caught between the door and the hydraulic bridge, resulting in an amputation without bone loss.

Two employees were using a plywood chop saw. The injured employee was holding one end of the saw with their right hand when the operator on the other end pressed the start button. The saw blade contacted the injured employee's right hand, resulting in multiple finger amputations when it amputated the hand above the thumb.

On January 17, 2025, at 12:15 p.m., an employee was moving 11-gauge steel sheets from a holding cart using a pendant-controlled, 1-ton jib hoist equipped with a plate clamp lifting attachment. With the plate clamp empty and open, the employee began raising the hoist. The clamp became caught on the bottom of the cart, tipping the cart in the direction of the employee. Several sheets of steel slid off the cart and struck the employee, resulting in several broken ribs, a broken left leg and ankle, a fractured kneecap, and a torn left ACL. The employee was hospitalized.

An employee was operating an air hoist to rotate a blending mill counter-clockwise. After he connected the hook to the mill, the hoist was raised and his hand was pinched between the hook block and the ring on the mill. The employee sustained a partial amputation of his right thumb.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.