McCain Fertilizer, Inc

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee was fixing an issue with seed cleaning equipment when he slipped on the ladder he was on. He went to catch himself and his hand went into a moving belt and pulley on the cleaner. The employee sustained the amputation of his right middle and index fingertips just below the fingernails.

At about 5:30 p.m. on September 23, 2025, an employee was unloading rubber mix material from a mixer. The employee's hand was caught by rotating parts in a discharge chute, causing a partial, soft-tissue amputation to a fingertip.

An employee was walking around a customer's truck. The truck door opened and caused the employee to trip and fall on a salt pallet. The employee suffered a compound fracture to the left arm.

An employee had delivered product to a customer and was driving a forklift to the rear of the delivery truck. The forklift jumped/bounced, sending the employee up into the air and back down onto the seat. The employee sustained a back fracture.

An employee was climbing an inspection ladder to observe the inside of a hopper. He slipped on the fourth rung, fell backward, and landed on his right foot on the ground about 38 inches below, suffering a broken right ankle.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.