Explosion of nonpressurized vapors, gases, or liquids · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Calpine Corporation, 530 Fairfield Road, PINE BLUFF, ARKANSAS 71601
on — Heat (thermal) burns, unspecified, affecting the multiple body parts, n.e.c..
Final narrative
On April 25, 2021, at 8:56 AM, natural gas pressure increased at the fuel skids which activated one of the pressure safety valves. An employee was dispatched to shut off the gas supply remotely. Natural gas discharged from the PSV and accumulated in four adjacent enclosures that house operating equipment. The gas vapors ignited and an explosion occurred. The employee was burned on both arms and hands, their face, and lower torso. The employee was hospitalized.
HospitalizedMultiple body parts, n.e.c.Natural gas
An employee was lighting the pilot light on a water heater. Gas ignited, causing a flash fire and explosion at the residential property. The employee suffered burns to the head, neck, upper torso, and upper extremities.
An employee was preparing a reach in cooler (fry cooler) and charging the system with refrigerant (R290)with his gauges. When the employee removed the gauges from the liquid line service valve, the refrigerant immediately escaped, and the liquid refrigerant exploded due to an unknown ignition source. The employee was burned on the face, hands, abdomen and knees.
An employee was lighting a gas stove/pizza oven when an explosion occurred due to a natural gas buildup. The employee sustained first- and second-degree burns to the face, neck, arms, hands, and legs.
An employee was re-lighting a sulfur burner while another employee increased the pressure on the gas valve. A gas explosion occurred. The employee sustained second-and third-degree burns to their arm, hand, chest, abdomen, and neck.
More severe injuries in this industry (NAICS 221119)
Employees were preparing to replace a primary electrical cable. While two of the employees were working to remove the cable on one side of a switchgear, they came into contact with a wrench and the outside part of the switchgear. One employee suffered an electrical shock.
An employee was installing personal protective grounds at a substation when their hand contacted the end of the ground that was not energized, but induced voltage was created by wind and shocked them. This resulted in a burn on their thumb.
At about 9:35 a.m. on March 18, 2024, an employee was conducting maintenance on a non-operational fan controller in a switchgear room. The employee pulled the controller and began installing a new one. The employee was electrocuted, suffering third-degree burns to the right hand and fingers as well as burns to the right forearm, and was hospitalized.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.