Caught in running equipment or machinery, unspecified · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Team Industrial Services, Inc., Lyondell Houston Refinery, HOUSTON, TEXAS 77017
on — Fractures, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was helping perform an inflatable line stop. During the line stop installation, the launch tube slid into the open valve, pinching the employee's left thumb between the locking clamp and the set point stopping block. The thumb was broken and lacerated.
An employee was removing a plug from a 3-inch pipe located under a drum. As they loosened seals on the plug, they were sprayed with hot water, resulting in thermal burns to their right arm, right abdomen, right thigh, and left hand.
An employee was performing bolting activities with a wrench. The employee's left index finger was caught between the wrench and a flange, and the fingertip was partially amputated.
An employee was ascending a ladder and slipped and fell to the ground, striking his head and back. The employee sustained a skull fracture with internal bleeding, two fractured vertebrae, and a fractured rib.
An employee was overseeing the manufacturing and machining of a part. The employee went to point to a mark on the part when his glove became caught in the vertical milling machine, resulting in amputation of the distal phalanx of the left index finger.
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was operating a lift truck when it struck a stationary lift truck. His left thumb was pinched between the two lift trucks, resulting in a partial amputation.
An employee was disassembling a pressurized unit using a driver drill. When the unit was disassembled, it caused a kickback from the tube head, causing the drill to strike the employee's left forearm. They sustained a diaphyseal fracture to their left radius and ulna, which required surgery.
After repairing a piece of industrial equipment, an employee had brake-cleaning liquid on his gloves. A lighter ignited the liquid, and the employee's hands were severely burned.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.