Fall through surface or existing opening 6 to 10 feet · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at JAY R REYNOLDS INC, 900 Hyland Ave, ABINGTON, PENNSYLVANIA 19001
on — Soreness, pain, hurt-nonspecified injury, affecting the hip(s).
Final narrative
An employee removed a piece of plywood to lay down some pipe, then moved to lean the plywood against a wall. The employee fell through a 3-foot by 4-foot hole that had been concealed under the plywood, landing 8 feet below in a crawlspace. The employee suffered a hip injury and was hospitalized.
An employee was standing on a 12-foot ladder, cutting a 3-inch water pipe. When he cut it, the pipe swung down and knocked the ladder out from under him. He fell to the ground about 9 feet below, landing on the ladder and suffering rib, lung, and hip damage.
An employee was laying out a 2-by-4 for railing on a second floor. The employee fell backward through an opening and landed on a concrete floor about 9.5 feet below, suffering broken vertebrae.
An employee was a spotter for a trap door that was being tested prior to a show. The trap door activated and the employee fell approximately 8 feet onto stunt mats that were covering the floor below. The employee sustained a fractured right shoulder, a dislocated right ankle, and a sprained left ankle.
An employee was moving a robot when they fell approximately 9 feet through a catwalk hole and landed on the floor. The employee sustained a head injury.
An employee was working in the attic of a modular home. As he was attaching a 2x4, the employee fell 9 feet through the ceiling to the ground. He sustained a fracture near the spinal cord.
More severe injuries in this industry (NAICS 238220)
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.
An employee was closing the side cargo door to a company van. The tip of his finger got caught between the door and the door jamb, resulting in a partial amputation.
While working at a customer's residence, an employee was cutting tape with a box cutter to wrap insulation for a piece of pipe. The box cutter struck a hardened object within the wall causing it to bounce back and puncture the employee's right eye. The employee was hospitalized.
An employee was assembling a baker type scaffold. He was beginning to transverse down the scaffold, approximately six feet off the ground, when the scaffold tipped over and he fell. The employee was hospitalized with a fractured femur.
An employee was trimming out sprinklers on the exterior of a building when he fell off an extension ladder. He landed on the ground and sustained fractures to his nose and arm.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.