Other fall to lower level more than 30 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Campbell Construction, Inc., Grand Parkway Bridge #8, DAYTON, TEXAS 77535
on — Fractures, affecting the head and trunk.
Final narrative
An employee was beginning to weld an angle iron on a new bridge when they fell approximately 51 feet from the bridge to the ground below, resulting in fractures to their face and ribs.
An employee was performing an inspection of the seed warehouse when they fell 30 feet from a catwalk to the ground. The employee sustained facial injuries and a compound fracture to the left femur.
An employee was on a cherry picker approximately 30 feet high, selecting boxes of merchandise from warehouse racking to place onto a pallet. The employee fell and sustained neck and back injuries.
On November 6, 2023, an employee was installing roofing materials on a multi-residential construction site 35 feet above ground level. The anchor on the employee's personal fall arrest system became unattached and the employee fell to the ground. They sustained multiple fractures.
On October 12, 2023, an employee was stacking insulation on a roof when they fell 35 feet through a skylight to the concrete floor below. The employee sustained an ankle and pelvis fracture.
On the fifth or sixth floor deck, an employee was supervising iron workers who were measuring to place rebar. The employee was struck by a wooden tool box that was being lifted by a tower crane. The employee then struck a wooden fence and fell approximately 50 feet to the ground. The employee sustained fractures to both legs and lacerations.
More severe injuries in this industry (NAICS 237990)
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.
Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.
A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.
An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.