West Fraser Mississippi

An employee was using a crane. The hook slipped and a fitting fell onto a finger on the employee's left hand causing a fracture and laceration.

An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.

An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.

An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.

An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.

An employee was operating a panel saw when a piece of wood got stuck in the dust collection vent. He was clearing the jam when the pressure bar (that holds the material) came down on his right hand and crushed his fingers. He sustained partial amputations to the middle and ring fingertips.

On September 3, 2025, a lumber handler was cutting a board with a circular saw when the saw blade grabbed his glove and pulled his hand into the saw. The blade amputated his left index finger and lacerated his left ring finger.

An employee was adjusting self-dumping steel hopper to get it to latch onto the tines of a forklift. He rocked the hopper back and forth to dump. The hopper slid off the forklift and fell about 2-3 feet down onto his legs. The employee sustained a cut on his head, a bruise on his face, and both his ankles were fractured.

An employee was using his left arm to pull a piece of lumber from a chain, which was on his right side, to stack it on a lumber bunk positioned to his left. His left middle fingertip was crushed between the end of the lumber he was moving and the stationary lumber stack behind him, resulting in an amputation.

An employee was pulling lumber through a chop saw when four of their left fingers were amputated.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.