Direct exposure to electricity, greater than 220 volts · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Sand Revolution II, 10800 West County Road 72, MIDLAND, TEXAS 79707
on — Electrical burns, unspecified, affecting the finger(s), fingernail(s), unspecified.
Final narrative
On July 9, 2021, employees were operating a mobile conveyor belt to load sand into a silo. The conveyor was experiencing belt issues and was being replaced with a new conveyor. The injured employee was operating the conveyor to fold it up so that it could be transported when the conveyor struck an overhead electrical line. The resulting arc flash burned the employee's left hand fingers.
An employee was covering an area of frac sand with a tarp to prevent rain damage. A gust of wind pulled the tarp while he adjusting it, and he slipped and fell off a ladder to the ground. He landed on his left hand and elbow, suffering a broken ulna.
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee was operating a rider pallet jack when it struck a stand-up forklift. The forks struck both of the employee's ankles, resulting in hospitalization.
An employee was working to repair a machine with a broken metal stopper. She removed the stopper and used a roll of tape to temporarily secure it. While she was moving it back into place to fix the machine, the residual pressure of the plastic pallets forced the stopper down, resulting in her right thumb becoming stuck between two metal parts. The thumb was amputated.
An employee was changing the battery on his forklift. He removed the forklift's battery plate and exited the battery machine alignment track. The shift lead then went to retrieve a new battery. The employee entered the battery machine alignment track again to unplug the charging cable. The battery changing equipment proceeded forward and pinned the employee against the forklift. The employee was hospitalized with two fractured ribs.
An employee took a picture of the seal and license plate on a delivery truck after loading. The truck then reversed back to the dock and pinned the injured employee against the dock. The employee sustained an abdominal fracture.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.