Struck by powered vehicle-nontransport, n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Laurel Motors Inc., 933 Eisenhower Boulevard, JOHNSTOWN, PENNSYLVANIA 15904
on — Fractures, affecting the pelvis.
Final narrative
An employee was on their knees with their upper body in a car while attempting to connect scanning equipment to an engine control module. The car went into drive and lurched forward. The driver's door struck a post and pinned the employee between the door and doorframe, resulting in a broken pelvis.
An employee was going to fill a pallet with items from the warehouse. He was reaching for the handle of the pallet jack but unintentionally grabbed the throttle, causing the pallet jack to move and pin him against another pallet jack. The employee sustained a leg fracture.
An employee was loading merchandise onto rolling containers that were on a remote-operated order picker. While reorganizing merchandise to prevent top loading, the employee's wireless control device contacted a container and caused the order picker to move forward. The employee's right ring finger was caught between two containers and was amputated above the first knuckle.
The injured employee was operating an elevator at a construction site. He went from the tenth floor to the eleventh floor with a plumber and a scissor lift in the elevator. The plumber was using a remote to operate the scissor lift. As the scissor lift was exiting the elevator, a pipe that was on the scissor lift struck the injured employee's chest. The employee was hospitalized.
An employee was dismantling the engine from a vehicle. The vehicle slid off the loader and struck the employee, pushing him into his toolbox. The employee sustained a broken jaw.
More severe injuries in this industry (NAICS 811118)
An employee was replacing the cutting edges on the bucket of a wheel loader. The bucket had been lowered onto composite blocking to prevent it from falling to the floor. The blocking dislodged and the bucket fell and crushed the employee's left hand.
An employee was walking on top of a piece of equipment while engaged in repair activities. The employee stepped onto a rotating impeller shaft of a belt-driven exhaust fan and sustained a partial amputation to their right leg below the knee and amputation of their left hand.
An employee was installing an automobile lift at a client location and put the lift on a safety lock. The employee's right hand was caught in the lift and crushed, causing the amputation of the little finger at the last knuckle and all of his right fingers were fractured.
On April 18, 2025, an employee was cutting the lid off an empty 55-gallon drum using a plasma cutter. The drum originally contained a flammable liquid and residual liquid inside the drum ignited and exploded. The employee was hospitalized with burns to the face, chest, and arms.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.