Struck by swinging or slipping object, other than handheld, n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Voith Hydro, 760 East Berlin Road, YORK, PENNSYLVANIA 17408
on — Fractures, affecting the upper and lower limb(s).
Final narrative
An employee was using a horizontal drill when a coolant hose became wrapped around the drill, broke free, and struck the employee multiple times, resulting in multiple fractures and lacerations to the right wrist and right shin.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 333611)
Four employees were traveling in a utility task vehicle (UTV) on the east lot of the site. While turning, the UTV flipped over onto the driver's side. The driver's left wrist and hand were crushed by the frame of the UTV resulting in a fractured and dislocated wrist, as well as hand injuries. The driver was hospitalized and required surgery.
On August 15th, 2025, an employee was aligning/connecting a coupler to the generator of a wind turbine. The coupler was secured in place by a strap that was connected to the turbine's chain hoist and a bolt. While lining up the remaining holes, the coupler rotated while the employee's right index finger was in one of the bolt holes, causing a partial amputation through the phalanx.
Employees were preparing to unload a wind turbine gearbox from a flatbed trailer. An employee went to reposition himself on the flatbed trailer and grabbed onto a wooden piece of the shipping cribbing for support. The piece of wood began to come loose, causing the employee to lose his balance. The employee jumped to the ground about 4 feet below and landed on his feet. His left ankle rolled and the employee was hospitalized with a fractured ankle that required surgery.
An employee was working to move a paper roller carriage, which is a 3 by 3-foot paper roll weighing approximately 500 pounds. The employee's hands were positioned in the area where the spool meets the cradle. As the employee moved the carriage across a floor track, the paper roll was dislodged and caught the employee's finger, severing it. The employee's right middle fingertip was partially amputated.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.