NITCO LLC

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee was helping unload steel slit coils on a slitting line, using an overhead crane with a C-hook. The coil did not fit properly onto a turnstile. Another operator went to remove the coil from the C-hook using a forklift while the employee held the C-hook steady. The forklift contacted the coil, causing it to fall from the hook. It landed on the employee s foot, breaking four bones. The incident took place during a training activity.

An employee was trying to open the stuck tailgate of a truck. When he pulled on it, it gave way, causing him to fall back and hit his head on the pavement. He suffered a head laceration/contusion.

An employee was mounting an ATV tire. As he was inflating it, the rim came out of the tire and struck his right leg, breaking it below the knee.

On July 25, 2025, an employee was lowering a vehicle on a lift. The employee's right index finger was caught in the lift and partially amputated.

An employee was performing a repair and using a radial arm saw when they lacerated their index finger. The employee was hospitalized with an infection.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.