North American Truck & Trailer, Inc.

An employee was applying downward pressure to a bent semi-truck bumper with a wheel lift when the bumper slipped and struck the employee. The employee sustained fractures to their ribs, shin, and patella.

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

An employee was working on disassembling and moving a trailer house from a gas well pad. The employee was on the roof of the structure installing flashing. The employee fell to the ground below, sustaining a skull fracture and brain bleed. The employee was hospitalized.

An employee was working on a truck when the truck's door fell on his hand, resulting in a partial amputation of the little finger.

The injured employee had been working on the computer at the front desk in the showroom. An argument occurred with another employee and additional people got involved. Gunshots were fired. The employee was shot in the hip and was hospitalized.

An employee was working on the lift gate of a truck when their left ring fingertip got caught in a pinch point, resulting in amputation.

An employee was preparing to remove leaf spring bushings on the front drive axle of a tandem axle tractor. After raising the axle with a hydraulic jack, he placed two jack stands under the rear frame rails of the tractor and placed additional jack stands under the front drive axle. He then repositioned himself at the rear of the tractor where he reached for the release valve of the jack to begin lowering the axle (and frame) onto the jack stands. He was in a kneeling position while using his right hand to operate the release valve. His left hand was caught between the lowering frame rail and a jack stand. His left ring and middle fingertips were crushed, resulting in amputations.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.

An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.

A skid loader backed over an employee's leg, breaking it.

An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.