ERC General Contracting

On October 26, 2023, an employee was riding on the forks of a forklift that was moving a stack of glass panels. The forklift made a turn and the glass fell on the injured employee, causing lacerations and crush injuries to their hands.

An employee was on a tractor and moving a stack of lumber when a board shot out from the stack and struck the employee's right leg. Their tibia was fractured and required surgery.

An employee was using a powered industrial vehicle (PIV) equipped with specialized horizontal clamps to move multiple heavy paper rolls. The top roll came loose from the clamps, falling towards the cab of the lift and lacerating the employee's middle and ring fingers.

An employee was helping a forklift operator move a steel joist. The joist struck a forklift tire, and as the forklift started to move, the joist shifted and struck the employee's right leg, resulting in a fracture.

An employee was using a pallet jack to move product from a truck to a customer location. A box on the top of the pallet shifted while the pallet was going over the bump of a dock plate and fell on the employee s head. Afterward, the employee experienced numbness in their limbs.

An employee was unloading frameless mirrors from a trailer. When unstrapped, the mirrors fell over onto the employee, who suffered a skull fracture, a brain bleed and blood clot, a broken left ankle, and lacerations.

An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.

An employee was inspecting the attic in a home. The employee stepped off the drop-down attic ladder onto drywall, fell through, and landed on the floor about 10 feet below. He suffered a broken left tibia.

An employee went aloft in a bucket truck to install a rubber cover-up for the pole set. He was proceeding to frame and transfer the conductors to the new pole when he sustained electrical burns on his left side, arm, and leg that required hospitalization.

An employee was positioned on a scaffold. They were using a level to adjust a pole and place bricks on the side of a wall. They fell approximately 30 feet from the scaffold to the ground, resulting in fractures to their back, rib, and heel.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.