Direct exposure to electricity greater than 220 volts · Electrical burns any degree
At a glance
Federal OSHA recorded a severe workplace injury
at Asplundh Construction LLC, Yates Crossing Road, MILTON, WEST VIRGINIA 25541
on — Electrical burns any degree , affecting the Multiple body parts n.e.c..
Final narrative
An employee went aloft in a bucket truck to install a rubber cover-up for the pole set. He was proceeding to frame and transfer the conductors to the new pole when he sustained electrical burns on his left side, arm, and leg that required hospitalization.
Hospitalized Multiple body parts n.e.c. Power lines, transformers, convertors
An employee developed a heat-related illness including body chills and cramping while setting utility poles. The employee was hospitalized with a muscle injury.
On February 9, 2021, at 1:45 pm, an employee was standing near a squirt boom utility truck putting away rigging equipment used during boring activities. A bucket truck was backing up and struck the employee, pinning them between the two trucks and resulting in fractures to their left ulna and radius about the wrist.
An employee was in the bucket of a truck making repairs to an electrical power system. He was shocked while using a drill to make a "hot tap," receiving an electrical burn on his left index finger.
An employee was exiting the bucket of an aerial lift truck when his foot missed the step, causing him to lose his grip and fall about 8 feet to the ground. He struck his head on the rear outrigger of the truck, suffering a broken C1 vertebra, torn vertebra ligaments, a skull fracture, and two broken ribs. He was hospitalized.
A crew was changing out a single-phase pole. The injured employee was framing the pole approximately 30 feet from the base. As they were loosening the armor rod clamp, the conductor broke and the wire fell to the ground, landing on the employee's right hand. The employee suffered electrical burns to their right hand and both knees.
An employee (a lineman) was working to restore power by installing a hand line when he contacted a high-voltage device (7,200 volts), resulting in electrical burns to his upper body and hands.
An employee was working from a bucket truck to remove a bolt from an attachment on an energized power line pole. The employee came into contact with the energized phase, resulting in an electrical shock of 7,200 volts. The employee was hospitalized. Protective gloves were not worn at the time of the incident.
On September 29, 2025, an employee was installing a fiber optic line at a residential site. His shoulder contacted the 7,600-kilowatt power line, resulting in an electrical shock. The employee was hospitalized.
Two employees exited their vehicle to assess a fully-downed power pole. The injured employee approached the downed pole to examine it more closely when their feet got caught underneath the energized phase and the ground of the pole, resulting in electrical burns to both feet.
More severe injuries in this industry (NAICS 236115)
An employee was unloading frameless mirrors from a trailer. When unstrapped, the mirrors fell over onto the employee, who suffered a skull fracture, a brain bleed and blood clot, a broken left ankle, and lacerations.
An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.
An employee was inspecting the attic in a home. The employee stepped off the drop-down attic ladder onto drywall, fell through, and landed on the floor about 10 feet below. He suffered a broken left tibia.
An employee was positioned on a scaffold. They were using a level to adjust a pole and place bricks on the side of a wall. They fell approximately 30 feet from the scaffold to the ground, resulting in fractures to their back, rib, and heel.
An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.
An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.
An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.