L & L Lumber Co., Inc.

An employee was operating a drill machine to drill pairs of holes into wooden boards. The employee noticed that the board was not correctly positioned and tried to move it with their left hand while at the same time lowering the lever used to lower the hold-downs/drill bit pairs with their right hand. The board would not move and their left hand slid along the board to one of the drill bit pairs. A drill bit caught the employee's glove and pulled a finger into the drill bit resulting in a fractured finger and partial amputation.

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

An employee was operating a panel saw when a piece of wood got stuck in the dust collection vent. He was clearing the jam when the pressure bar (that holds the material) came down on his right hand and crushed his fingers. He sustained partial amputations to the middle and ring fingertips.

On September 3, 2025, a lumber handler was cutting a board with a circular saw when the saw blade grabbed his glove and pulled his hand into the saw. The blade amputated his left index finger and lacerated his left ring finger.

An employee was adjusting self-dumping steel hopper to get it to latch onto the tines of a forklift. He rocked the hopper back and forth to dump. The hopper slid off the forklift and fell about 2-3 feet down onto his legs. The employee sustained a cut on his head, a bruise on his face, and both his ankles were fractured.

An employee was using his left arm to pull a piece of lumber from a chain, which was on his right side, to stack it on a lumber bunk positioned to his left. His left middle fingertip was crushed between the end of the lumber he was moving and the stationary lumber stack behind him, resulting in an amputation.

An employee was pulling lumber through a chop saw when four of their left fingers were amputated.

An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.

An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.

An employee was shot in the leg with a pistol during an altercation with two people who had entered the store without permission.

An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.

An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.