Other fall to lower level 21 to 25 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Frontier Bridge, Inc., Custer County Bridge #287 worksite, CLINTON, OKLAHOMA 73601
on — Fractures, affecting the foot(feet) and leg(s), unspecified.
Final narrative
An employee was on a bridge placing plywood for diaphragm decking. A piece of plywood was blown into him and he fell from the bridge to the ground level about 25 feet below. He suffered fractures to the right leg and foot.
HospitalizedFoot(feet) and leg(s), unspecifiedBridges, dams, locks
On November 5, 2018, an employee was placing scrap metal onto a trailer when the load began to shift and the employee dismounted from the trailer. A few pieces of steel slid from the trailer and onto the employee's right leg, fracturing the tibia and fibula. The employee was hospitalized and had surgery.
An employee was getting a tool bag that was on a second-story roof when they fell from the roof to the ground. The employee was hospitalized with injuries to their rib cage and lower back.
An employee was installing a clip on the roof when they slipped and fell approximately 25 feet to the ground below, resulting in a broken hip, broken leg, and bleeding in the brain.
An employee was setting up the worksite for the day. While moving an extension cord, he fell backward off the roof of the two-story building and sustained a broken pelvis.
An employee was going up in a lift to begin trimming trees with a chainsaw. He was approximately 20-25 feet in the air when the latch to the bucket got caught and detached. The bucket then tipped causing the employee to fall to the ground. He sustained fractures to his right elbow, right wrist, and left femur.
An employee was laying down felt paper on a new residential property when they fell approximately 21 feet to the ground. The employee sustained fractures of the L2 vertebra, right tibia, and left wrist as well as a left heel dislocation. The employee was wearing fall protection at the time.
More severe injuries in this industry (NAICS 237310)
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.