Caught in running equipment or machinery, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at ARANDELL CORPORATION, N82 W13118 LEON ROAD, MENOMONEE FALLS, WISCONSIN 53051
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was adjusting a belt on a conveyor. The employee's left index and middle fingers were caught in the conveyor's chain and sprocket, and both fingertips were amputated at the first joint.
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
An employee opened a 480-volt breaker box and reached inside the breaker box when an uninsulated tool came in contact with one of the legs, causing him to be electrocuted. The employee's arm also got caught on the box, resulting in breaks to both bones in the forearm.
An employee was disconnecting a truck from a trailer. While pulling the fifth-wheel release that the trailer was attached to, the employee lost balance and fell backward onto the concrete pavement, resulting in a fractured T12 vertebra.
An employee was operating a UV coater machine when it began to make a grinding noise. The employee was investigating the vibration of the machine when a gear caught their right index finger and amputated the tip.
A temporary employee was operating a seal machine to seal paper bundles. A jam occurred when the paper and plastic did not properly align to secure the seal. The employee went to clear the jam and the blade on the machine amputated their right middle finger.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.