Kelmann Corp.

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

An employee was on an extension ladder descending from a roof when the ladder collapsed and lowered. The employee fell approximately 20 feet to the ground, resulting in fractures to their ribs and left wrist.

The injured employee was acting as a spotter for another employee that was using a forklift to move crane plates. The injured employee went to walk on top of staged bracing poles that had been stacked. The top layer of bracing shifted when stepped on, causing the employee to lose balance and fall. During the fall, one of the bracing poles dislodged and landed on the employee s left leg, causing a compound fracture.

An employee was working to remove an existing window from a customer's home. The employee was descending an extension ladder when they fell backward onto a concrete patio. The employee sustained head trauma and fractures to their shoulder, ribs, and a vertebra.

An employee was painting the exterior of a house when they fell approximately 12 feet from a ladder. They landed on the ground and sustained a fractured right ankle.

An employee climbed a ladder onto a roof, then stepped from new roof sheathing onto a tarped section of old roof, and fell to the ground. The employee suffered fractures to their pelvis, vertebrae, and the left wrist. The employee was hospitalized.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.