Sunset Home Specialist, LLC

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.

An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.

An employee was on an extension ladder descending from a roof when the ladder collapsed and lowered. The employee fell approximately 20 feet to the ground, resulting in fractures to their ribs and left wrist.

The injured employee was acting as a spotter for another employee that was using a forklift to move crane plates. The injured employee went to walk on top of staged bracing poles that had been stacked. The top layer of bracing shifted when stepped on, causing the employee to lose balance and fall. During the fall, one of the bracing poles dislodged and landed on the employee s left leg, causing a compound fracture.

An employee was working to remove an existing window from a customer's home. The employee was descending an extension ladder when they fell backward onto a concrete patio. The employee sustained head trauma and fractures to their shoulder, ribs, and a vertebra.

An employee climbed a ladder onto a roof, then stepped from new roof sheathing onto a tarped section of old roof, and fell to the ground. The employee suffered fractures to their pelvis, vertebrae, and the left wrist. The employee was hospitalized.

Employees were setting a piece of stone backsplash (about 4 by 5 feet) in a kitchen at a residential job site. The piece fell and caught an employee's left middle finger against a countertop. The fingertip, about half to three-quarters of an inch, was amputated.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.