Portland Country Club

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

An employee slipped on some spilled sauce in the walk-in cooler and fell, hitting the front of his head on the concrete. Approximately 30 minutes later, he became ill, collapsed, and had a seizure. The employee was hospitalized with an intraparenchymal hemorrhage (IPH).

At about 5:50 a.m. on August 14, 2025, an employee was changing tee cups on a golf course. He stepped away to the brush to grab a branch from the ground and a rattlesnake bit the top of his right hand.

An employee exited a utility or golf cart that was moving at about 10 mph. The employee lost his footing and hit his head on cement pavement, suffering head trauma with a loss of feeling. The employee was hospitalized.

An employee was trimming hedges when he slipped and his right thumb contacted the blades of the hedge trimmers. He sustained amputation of approximately 80% of the right thumb beyond the first joint and a laceration to the right index finger.

On July 28, 2025, an employee was removing ice buildup from the floor of a walk-in freezer. He was melting the ice with warm water when he slipped and fell on the floor. The employee was hospitalized with fractures to his left leg/ankle and he required surgery.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.