Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Daktronics, Inc, 201 DAKTRONICS DRIVE, BROOKINGS, SOUTH DAKOTA 57006
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was bending a metal bracket in a brake press. During the last bend, the employee's fingers were caught between the part and the top of the tooling. The employee's right middle, right ring, and left ring fingertips were amputated (without bone loss).
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 339950)
An employee was operating a hand-powered drill to drill holes into plastic clips. The drill bit snagged on a plastic clip and spun the clip around, resulting in an a laceration to her left index finger that required surgical amputation.
An employee was using a table saw to make a dado cut on a piece of wood. The piece of wood contacted the blade, which pulled in the employee's hand. The blade severely cut the employee's left palm.
An employee was shearing sheet metal with a shear machine activated by a foot peddle. When he hit the foot pedal, one of the springs crushed his finger, resulting in a partial fingertip amputation.
An employee was working on a motorized screen when they fell approximately 3 feet from a step ladder to the ground. The employee sustained a face contusion and a fractured jaw.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.