CAM Superline, Inc.

An employee was using a crane. The hook slipped and a fitting fell onto a finger on the employee's left hand causing a fracture and laceration.

An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.

An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.

An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.

An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was assisting with rigging a magnet to an overhead crane in order to lift a sheet of steel. The employee's right thumb was between the crane's hook and the chain passing through the hook, and when the crane was raised, the distal end of their thumb was crushed. Part of the employee's right thumb was medically amputated.

Two employees were working together to insert a pin into a hydraulic cylinder. One employee was holding the cylinder in place to align it with the pinhole, while the injured employee was inserting the pin. The injured employee was aligning the pin and moved to determine whether the hole alignment was too high or low. At that moment, the crowbar being used to assist with alignment slipped and his left index fingertip was pinched between the cylinder and the housing, resulting in an amputation just below the fingernail.

An employee was hoisting an axle in the buggy department when one side of the sling came loose, causing the axle to tip. The sling hook raised up from the weight transfer, causing the employee's left little finger to be caught by the rigidness of the hook. The fingertip was amputated.

An employee was using a circular saw to cut the cap off an aluminum bulkhead of a trailer that was being manufactured. The saw kicked, lacerating his hand and resulting in the amputation of his left middle and ring fingertips.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.