Idaho Timber Corporation

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

An employee was operating a panel saw when a piece of wood got stuck in the dust collection vent. He was clearing the jam when the pressure bar (that holds the material) came down on his right hand and crushed his fingers. He sustained partial amputations to the middle and ring fingertips.

On September 3, 2025, a lumber handler was cutting a board with a circular saw when the saw blade grabbed his glove and pulled his hand into the saw. The blade amputated his left index finger and lacerated his left ring finger.

An employee was adjusting self-dumping steel hopper to get it to latch onto the tines of a forklift. He rocked the hopper back and forth to dump. The hopper slid off the forklift and fell about 2-3 feet down onto his legs. The employee sustained a cut on his head, a bruise on his face, and both his ankles were fractured.

An employee was using his left arm to pull a piece of lumber from a chain, which was on his right side, to stack it on a lumber bunk positioned to his left. His left middle fingertip was crushed between the end of the lumber he was moving and the stationary lumber stack behind him, resulting in an amputation.

An employee was pulling lumber through a chop saw when four of their left fingers were amputated.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.