MENOMONEE FALLS, WISCONSIN—
Willkomm Excavating & Grading, Inc.
Direct exposure to electricity, greater than 220 volts · Electrocutions, electric shocks
At a glance
Federal OSHA recorded a severe workplace injury at Willkomm Excavating & Grading, Inc., Clover Lane & Silverspring Drive, MENOMONEE FALLS, WISCONSIN 53051 on — Electrocutions, electric shocks, affecting the bODY SYSTEMS.
Watch Willkomm Excavating & Grading, Inc. — free
Get an email when a new federal OSHA severe-injury report for Willkomm Excavating & Grading, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was using a grade pole to measure the grade in a trench box. As the employee was pulling the pole out of the trench box, the pole was blown into an electric line by a gust of wind, causing the employee to be electrocuted. The employee was hospitalized.
Similar incidents · Same event type
S COFFEYVILLE, OKLAHOMA—
Star Pipe USA LLC
An employee was making modifications to an electrical panel when an arc flash occurred. The employee suffered burns to multiple parts of the body.
MIDLAND, TEXAS—
Star Electric Company of Texas
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
CLEARWATER, FLORIDA—
Powertown Line Construction LLC
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
WILLARD, OHIO—
Stanley Black and Decker, Inc
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
KERSEY, COLORADO—
Sun Valley Contractors, LLC
An employee had just turned off breakers and was loosening wires on panels when they were shocked by 480 volts of electricity.
More severe injuries in this industry (NAICS 237110)
RAPID CITY, SOUTH DAKOTA—
Simon Contractors of South Dakota, Inc.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
PINELLAS PARK, FLORIDA—
Cypress Gulf Development Corp.
An employee fell while stepping off the tailgate of a pickup truck. The employee landed on the ground and suffered a broken left fibula and tibia.
BURLESON, TEXAS—
Circle H Contractors, LP
On October 7, 2025, employees were conducting trenching operations for the installation of a new sewer line system. The excavator's bucket was detached and put inside the trench as it was being exchanged for a different-sized bucket. An employee entered the trench with a shovel to move some dirt located at the front end of the pipe. The excavator bucket shifted and slid, striking the employee s right foot and trapping it against the ground. The employee sustained a fractured right tibia.
ESTERO, FLORIDA—
WPM-Southern, LLC
Employees were working to dislodge a large truck that was stuck in a rut using tow straps and a front-end loader with the bucket removed. An employee connected the straps to the loader and truck and another employee slowly engaged the loader to close the coupler. The injured employee's arm became caught in a pinch point. The employee was hospitalized with a fractured arm.
SANFORD, FLORIDA—
Garrison Enterprise Inc.
An employee was lifting a piece of 30-inch line stopping equipment using a jack screw. A lifting eye weld snapped and the load dropped. The end of the jack screw then landed on the employee's heel and crushed it. The employee was hospitalized.
More severe injuries in WISCONSIN
MADISON, WISCONSIN—
RG Professional Carpenter, Inc.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
FRANKLIN, WISCONSIN—
General Thermodynamics, Inc.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
SAINT CLOUD, WISCONSIN—
Sargento Foods Inc
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
HIXTON, WISCONSIN—
Asher Enterprises, Inc.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
VERONA, WISCONSIN—
Consolidated Electrical Distributors Inc.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.