Fiberglass Solutions LLC

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

On July 17, 2025, an employee was informed that the overtravel cable came off the wire rope drum. He went to unwind the rope drum. The bucket moved and caused the rope to tighten on the employee's right thumb, resulting in a partial amputation.

AN employee was working on the automated feed line when the pusher jammed. The employee cleared the jam, which caused the pusher to activate the press. The employee's right middle, ring, and little fingers were caught between the press mechanism and the material, resulting in amputations to the fingers.

An employee was walking down a ramp from a parking lot toward a building. The employee slipped on snow and ice and fell, suffering a back injury.

An employee was installing a belt onto the sheave of a fan motor. The machine was being rotated by hand to put a new belt in place when the employee's fingers got caught between the machine and the belt, resulting in a partial amputation of the little fingertip.

An employee was preparing a glass melter for extensive repairs. Water was being introduced into the melter with a lance to break up the hot glass. The water caused the molten glass to exit the melter with force, contacting the employee. The employee sustained thermal burns to their forearm, neck, and head.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.