Fall on same level due to slip or trip · Traumatic injuries or exposures unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Tricon Industries, 4020 NW 36th Street, LINCOLN, NEBRASKA 68524
on — Traumatic injuries or exposures unspecified, affecting the Exterior and musculoskeletal structures of the back unspecified.
Final narrative
An employee was walking down a ramp from a parking lot toward a building. The employee slipped on snow and ice and fell, suffering a back injury.
Hospitalized Exterior and musculoskeletal structures of the back unspecified Ramps, inclines
An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.
On July 17, 2025, an employee was informed that the overtravel cable came off the wire rope drum. He went to unwind the rope drum. The bucket moved and caused the rope to tighten on the employee's right thumb, resulting in a partial amputation.
AN employee was working on the automated feed line when the pusher jammed. The employee cleared the jam, which caused the pusher to activate the press. The employee's right middle, ring, and little fingers were caught between the press mechanism and the material, resulting in amputations to the fingers.
An employee was installing a belt onto the sheave of a fan motor. The machine was being rotated by hand to put a new belt in place when the employee's fingers got caught between the machine and the belt, resulting in a partial amputation of the little fingertip.
An employee was preparing a glass melter for extensive repairs. Water was being introduced into the melter with a lance to break up the hot glass. The water caused the molten glass to exit the melter with force, contacting the employee. The employee sustained thermal burns to their forearm, neck, and head.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.