Indirect exposure to electricity, greater than 220 volts · Electrocutions, electric shocks
At a glance
Federal OSHA recorded a severe workplace injury
at Black Gold Farms, Outside of State Hwy 77 and CR W102, LEACHVILLE, ARKANSAS 72438
on — Electrocutions, electric shocks, affecting the bODY SYSTEMS.
Final narrative
An employee in the field was troubleshooting an operation control issue on a 480-volt irrigation pivot. While perched on the built-in ladder, the employee's screwdriver made contact with an energized contactor screw, resulting in an electric shock. The employee was temporarily disoriented, felt chest pain, and climbed down from the equipment. The electrical shock caused an irregular heartbeat.
An employee was grating sweet potatoes on a harvester when their right ring finger got caught in a belted chain on the harvester, resulting in a fingertip amputation.
An employee was using a produce bagger machine to fill sacks with potatoes when the machine's pneumatic clamp crushed the employee's left pinky finger, requiring amputation without bone loss.
An employee was driving an open cab tractor when a tree limb lacerated his cheek. The scratch later became severely infected and required hospitalization the following day.
A crew was working near an electrical pole. A co-worker was using a front-loader to grade a slope when the loader slid into a guy-wire and became tangled and stuck. The injured employee used a handheld grinder to cut the wire a few feet from the ground. The lower part of the wire fell to the ground, but the upper part of the wire fell toward the pole and contacted an energized part before the end landed in nearby bushes. The employee attempted to shake the bush to free the wire so it could fall back toward the pole. The wire popped up and contacted his hands, resulting in electrical entry burns to both hands and exit burns on both feet.
On November 18, 2023, two employees were using a 2x4 to lift a power line. The boom lift they were operating made contact with power lines and both employees sustained electrical shock injuries.
An employee was part of a crew that was servicing a power line. The employee was in a bucket truck when he contacted the 7,200-volt power line. The electricity entered through one hand and exited the other, causing several electrical burns. The employee was not wearing proper personal protective equipment at the time.
An employee was helping a crew set up a 45-foot pole between two other poles. It was being set up between two energized lines and the pole made contact with the A-phase. The employee was electrocuted and lost consciousness. The electricity also caused an entry wound in their left forearm and an exit wound in their left foot.
An employee was handling a 45-foot long rebar for installation on the third floor of a building at a 30-foot elevation. The rebar came into close proximity of a powerline situated 13 feet off the building. The employee sustained electrical burns to his hands from electric discharge, requiring hospitalization.
More severe injuries in this industry (NAICS 311991)
An employee was painting a wall. They fell down three steps and landed on a plastic mop bucket and the floor. The employee was hospitalized with fractures to their right arm and right hip, and required surgery.
An employee was using an electric jack to load a pallet onto a truck when he was struck from behind by a forklift, resulting in a laceration to his right leg.
An employee was performing maintenance on a tray packer. They put a piece of cardboard down onto the belt of the tray packer and stood on the belt. The belt started, causing the employee to lose balance and fall approximately 2 feet. The employee was hospitalized with a fractured ankle and required surgery.
An employee was adding cilantro to the dicing machine when it became jammed. While clearing the jam, the blade amputated approximately 1/2" to 3/4" of his right middle finger.
An employee was cleaning and sanitizing a mixer when the machine was activated. The employee's hand was caught in the machine and he sustained the amputation of his right hand. The employee was hospitalized.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.