Indirect exposure to electricity, greater than 220 volts · Electrocutions, electric shocks
At a glance
Federal OSHA recorded a severe workplace injury
at Commonwealth Edison Company, Intersection of Pawnee Drive and Morton Road in Carol Stream, IL, CAROL STREAM, ILLINOIS 60188
on — Electrocutions, electric shocks, affecting the bODY SYSTEMS.
Final narrative
An employee was helping a crew set up a 45-foot pole between two other poles. It was being set up between two energized lines and the pole made contact with the A-phase. The employee was electrocuted and lost consciousness. The electricity also caused an entry wound in their left forearm and an exit wound in their left foot.
HospitalizedBODY SYSTEMSUtility and telephone poles
More severe injuries at Commonwealth Edison Company
A crew was removing old distribution poles. As they were removing the bottom section of a pole post, a winch line became tangled with slack. Two of the employees climbed on top of the crew's truck to fix the issue. The load then pulled the winch line tight around the finger of one of the employees, causing the amputation of their fingertip.
While completing a capacitor bank storage installation, an employee came into contact with live equipment and suffered electrical burns to the arms and torso.
A crew was working near an electrical pole. A co-worker was using a front-loader to grade a slope when the loader slid into a guy-wire and became tangled and stuck. The injured employee used a handheld grinder to cut the wire a few feet from the ground. The lower part of the wire fell to the ground, but the upper part of the wire fell toward the pole and contacted an energized part before the end landed in nearby bushes. The employee attempted to shake the bush to free the wire so it could fall back toward the pole. The wire popped up and contacted his hands, resulting in electrical entry burns to both hands and exit burns on both feet.
On November 18, 2023, two employees were using a 2x4 to lift a power line. The boom lift they were operating made contact with power lines and both employees sustained electrical shock injuries.
An employee was part of a crew that was servicing a power line. The employee was in a bucket truck when he contacted the 7,200-volt power line. The electricity entered through one hand and exited the other, causing several electrical burns. The employee was not wearing proper personal protective equipment at the time.
An employee was handling a 45-foot long rebar for installation on the third floor of a building at a 30-foot elevation. The rebar came into close proximity of a powerline situated 13 feet off the building. The employee sustained electrical burns to his hands from electric discharge, requiring hospitalization.
An employee was changing out insulators and hardware on a lattice 230-kilovolt tower when he saw that the pin that was securing the V-string to the outside phase was falling out. He hooked up a chain hoist to stop it. While going down, the employee dropped the chain hoist, causing it to go by a 69-kilovolt line. He suffered an electric shock by induction, which resulted in third-degree burns on his finger, back, and buttocks.
More severe injuries in this industry (NAICS 221122)
An employee was setting up communication equipment for a meeting. They were walking and tripped over a speaker on the ground. The employee sustained a leg injury.
An employee (a lineman) was working to restore power by installing a hand line when he contacted a high-voltage device (7,200 volts), resulting in electrical burns to his upper body and hands.
A chain sling failed while a utility pole was being removed. A chain link struck an employee who was operating a front-end loader, puncturing the employee's chest.
An employee was working with an underground crew to troubleshoot a BUD failure. The employee was removing a fuse from the fuse holder when the fuse blew on the riser and an arc flash occurred. The employee was hospitalized with burns to his face, nose, lips, and neck.
An employee was connecting two wires when his rubber insulated gloves failed and he suffered an electric shock to his right hand, resulting in an electrical burn.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.