Fall on same level due to tripping, unspecified · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Eurofins Viracor, 18000 West 99th Street, LENEXA, KANSAS 66219
on — Fractures, affecting the chest, except internal location of diseases or disorders.
Watch Eurofins Viracor — freeGet an email when a new federal OSHA severe-injury report for Eurofins Viracor is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was walking into a building when they tripped and grabbed a construction stanchion that fell over causing the employee to fall on their left shoulder and elbow. The employee sustained three broken ribs.
HospitalizedChest, except internal location of diseases or disordersFloors, walkways, ground surfaces, unspecified
An employee was walking down the hall to retrieve a vacuum when they stumbled and fell to the floor. The employee suffered wrist bruises and a kneecap fracture that required surgery.
An employee was installing a compressor piston. He tripped and fell backward while the piston was in his lap. As he landed, the little finger of his left hand became caught between the piston and compressor piping resulting in a partial amputation of the fingertip. The employee required stitches and the fingertip was reattached.
An employee was doing an oil change. He was walking to get his oil jug when he tripped on an open lift pad, and fell to the ground landing on his right side. The employee sustained a broken right femur and was hospitalized.
More severe injuries in this industry (NAICS 541990)
Employees were conducting a snubbing operation. While making up the tubing swivel onto the joint in the mouse hole, employee 2 proceeded to pull power tongs off the pipe. At the same time, the injured employee went to re-adjust the tong heads. The make/brake handle was pulled and the injured employee's right hand got caught in the tongs. The injured employee's index, middle, and ring fingers were amputated and he required surgery.
On 9/26/2025, an employee was using a pair of scissors to cut a zip-tie that was securing a box of files. The scissors slipped and lacerated the employee s left wrist. The employee was hospitalized.
An employee was troubleshooting and rodding out a piece of process piping equipment when their left index finger was caught between the tool handle and threaded flange. The employee's fingertip was partially amputated.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.