Caught in running equipment or machinery, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Franklin Corporation, 600 Franklin Drive, HOUSTON, MISSISSIPPI 38851
on — Amputations, affecting the buttock(s).
Final narrative
An employee sat on a foam block, located on a band saw's moving table, while adjusting the foam. The band saw blade lacerated part of the employee's left buttock and left calf.
An employee was cutting wood parts on a band saw. The saw cut her left index finger at the knuckle closest to the palm and the employee sustained an amputation to the left index finger.
An employee was changing a bit on a CNC router. When he reached under the machine, the still-spinning bit cut and lacerated his left hand in several places, from the palm to the thumb.
An employee was operating a rivet machine. As the employee was removing a rivet stuck in the slot, the machine activated and smashed his left index finger. He suffered a partial amputation to the finger.
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
On September 13, 2024, the injured employee was walking through an aisle where a co-worker was removing pallets from the racking system using an order picker. The corner of a pallet being moved contacted the corner of a skid next to it, causing two empty pallets to fall 12 to 16 feet from the racking onto the injured employee. The employee sustained a laceration and contusions to the back of their head and left shoulder.
An employee was operating a panel saw. The machine malfunctioned and the employee went behind it to try and fix it. When he adjusted a valve, the machine activated and moved forward trapping him between the beam and the wood preparing to load. The employee sustained fractured ribs and injury to the abdomen and chest areas.
An employee was cutting wood parts on a band saw. The saw cut her left index finger at the knuckle closest to the palm and the employee sustained an amputation to the left index finger.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.