Pedestrian struck by vehicle backing up in roadway · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Folsom Tree Service, LLC, 3 Cherry Valley Dr, LITTLE ROCK, ARKANSAS 72211
on — Fractures, affecting the thigh(s).
Final narrative
An employee was standing on the street, preparing to leave a job site. A pickup truck with a wood chipper trailer was backing up and pinned the employee against the front of a skid steer. The employee suffered multiple fractures to the right femur.
An employee was standing at the rear of a garbage truck loading trash when the front passenger tire struck his ankle/foot. The employee was knocked down and the tire rolled over him, resulting in fractures to his ribs and ankle.
On October 8, 2021, an employee was on the back side of a truck, giving the driver directions to back up the truck to get close to two garbage cans. The truck struck him, causing fractures to his pelvic bone and sacrum. He was hospitalized.
An employee was helping to set up a mulch blowing truck when they were struck by an oncoming vehicle. The employee was hospitalized with a fractured knee, a concussion, and a head laceration; they also received stitches on their arm.
An employee was using a table saw to cut a piece of wood when the saw cut his thumb, index, and middle fingers. His index finger was amputated and he was hospitalized.
An employee was mowing a residential lawn at a client's house. The mower slid on the land and tipped over onto him. The employee was hospitalized with a fractured vertebra in the neck and partial paralysis.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.