Caught in running equipment or machinery during regular operation · Fractures and dislocations
At a glance
Federal OSHA recorded a severe workplace injury
at Kelly Manufacturing Co., 80 Vernon Drive, TIFTON, GEORGIA 31793
on — Fractures and dislocations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was sanding a shaft on a turret lathe with strips of sandpaper. The sandpaper caught on a shaft, causing it to wrap around the shaft and contact the employee's gloves, pulling them off while pulling the employee's left hand into the shaft. The employee suffered lacerations to their hand and dislocated and broken fingers that required hospitalization.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332510)
An employee was working on a portable stainless-steel vessel equipped with a butterfly valve at the bottom. The employee used a crane to raise the vessel and connected an airline to the valve control. Upon activating the compressed air supply, the valve opened. While holding the bottom of the vessel with their left hand, the airline disconnected and the valve closed on their left index fingertip. The employee sustained an avulsion of the fingernail, an open nondisplaced fracture of the distal phalanx, and partial amputation of the fingertip.
An employee was in training to learn how to change steel dies on a culvert machine. The employee was on top of the machine when the handheld control was activated, engaging the machine's auto-run function. The employee's feet were dragged into the roller dies, resulting in a left ankle fracture, a laceration between the ankle and knee, and amputation of the the big toe and second toe on the right foot.
An employee was walking up the stairs in an office area. Their right foot caught the edge of the stair at the top of the stairwell and they fell forward. The employee sustained a neck fracture.
An employee was operating a clipper machine and contacted maintenance when they noticed the machine was not working properly. Maintenance worked on the machine. While verifying that the machine was fixed, the employee's left index finger was amputated above the first knuckle.
An employee was feeding a strip of steel into a power press when it activated and contacted the injured employee's left hand. The employee suffered amputations of the first two digits of the hand.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.