Fall or jump curtailed by personal fall arrest system · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at West Tree Service, Inc., 4579 Malvern Rd, HOT SPRINGS, ARKANSAS 71901
on — Soreness, pain, hurt-nonspecified injury, affecting the multiple body parts, n.e.c..
Final narrative
An employee was working from a bucket lift, removing a tree in sections. He lost his balance while pushing on a section and fell. His fall protection caught him and he swung into a tree, suffering an injury that caused head, neck, and leg pain, as well as loss of consciousness while he was at the hospital.
HospitalizedMultiple body parts, n.e.c.Aerial lifts, scissor lifts-except truck-mounted
An employee was trimming tree branches from an aerial lift. As they were maneuvering the aerial bucket lift from inside, the truck drove over soft ground and tipped over. The bucket lift fell to the ground with the employee tied off inside, resulting in rib fractures.
An employee was walking along a trench inspecting the trench box in the excavation when he tripped and fell toward the trench. As the employee was falling head-first into the trench, he attempted to get a hold of the fall protection cable. The cable then looped around his left hand and the employee fell approximately 8 feet into the trench before the fall protection engaged. The employee suffered amputations of his left index, middle, ring, and little fingers.
A ranger was performing back-country patrol duties while hiking. As they were climbing a technical rock patch, a rock handhold broke, causing the employee to fall approximately 15 feet before their belay engaged. The employee contacted a rock, resulting in a fracture to the right ilium as well as a subcutaneous hematoma to the right gluteal region.
Employees were erecting structural steel. The injured employee was sitting on a 12" wide horizontal member and lining up an I-beam brace as it was suspended by an overhead crane. He leaned left to push the end of the brace. The end of the suspended brace swung away from him, causing him to lose balance and fall 8 feet. His personal fall arrest system arrested his fall, but he swung into a piece of duct work during the fall that resulted in a concussion.
On September 12, 2022, an employee was on a metal roof, installing a standing seam and insulation. He lost his balance and fell toward the third floor slab, which was 10 feet from the roof. His fall protection caught him and left him suspended about 2 to 4 feet from the slab. He suffered a brain bleed and a spinal fracture in his lower back. He was hospitalized.
An employee fell from a steel beam. His fall protection caught him, but the momentum swung him into a concrete block wall. His head struck the wall and he was knocked unconscious, suffering a skull fracture and a brain bleed.
More severe injuries in this industry (NAICS 561730)
An employee was helping to set up a mulch blowing truck when they were struck by an oncoming vehicle. The employee was hospitalized with a fractured knee, a concussion, and a head laceration; they also received stitches on their arm.
An employee was using a table saw to cut a piece of wood when the saw cut his thumb, index, and middle fingers. His index finger was amputated and he was hospitalized.
An employee was mowing a residential lawn at a client's house. The mower slid on the land and tipped over onto him. The employee was hospitalized with a fractured vertebra in the neck and partial paralysis.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.