TenCate Geosynthetics

An employee was checking the speed of an exit roll using a tachometer when the employee's right hand was pinched between the roll and table, amputating and fracturing the second digit and lacerating the third digit.

An employee was walking back to her workstation. A forklift reversed a short distance, then completed a U-turn and struck her, running over her lower extremities. She was hospitalized with a broken ankle.

An employee was training on a jockey truck. Upon stepping out of the truck, the employee was struck by a rubber tire gantry crane, resulting in amputations of the right leg above the knee and left leg below the knee.

An employee was standing at the rear of a double pallet jack. Another double jack approached, and the employee's lower leg was caught between the two pieces of equipment. He suffered a broken tibia and fibula.

An employee was unloading large material bags on a loading dock. A forklift tine pinned the employee's foot against a pallet, causing the employee to fall and suffer a broken ankle.

An employee was pushing a container when they were struck by a forklift. The employee sustained a left leg fracture.

On August 25, 2025, a machine operator was working on the heat-set end of a textile bleach/prep range machine. He was running leader cloth and it was bunching up. He climbed a catwalk so he could reach the cloth and flatten it out. His right hand was caught in a nip roll while adjusting the cloth. The employee's middle and ring fingertips were amputated.

An employee was making a fiber. He used his right hand to smooth the ends of polypropylene yarn and ensure they wrapped evenly onto a beam, spinning at 7 RPM. Some yarn got wrapped around his right middle finger and lacerated the finger and removed the nail, resulting in a distal amputation.

An employee was climbing down a ladder from the top of a machine 8 feet above the ground. He missed the second-to-last rung from the bottom and fell to the floor, suffering a broken right tibia and fibula.

On July 19, 2024, an employee was preparing to start the warp machine and was wrapping the yarned ends around the beam. Their right hand went behind the beam and between the press roll, bypassing the guard. When the machine started, it crushed their right hand. The employee was hospitalized.

An employee was using a utility knife to remove film from a roll of material for a coder machine when the knife became stuck. He pulled his arm back to free the knife. When the knife came free, it cut his left arm between the wrist and elbow.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.