Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Tyson Foods, Inc., 1019 Shelbyville Street, CENTER, TEXAS 75935
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
On November 11, 2022, an employee was replacing a sprocket and bearings on a shaft. The employee used a lathe in the maintenance shop to clean the shaft when their hand came in contact with a portion of the rotating equipment on the lathe. He sustained amputations of two fingers on his left hand and a finger fracture.
On September 3, 2025, an employee was leaving a facility at the end of her shift. As she was going through the exit doors of the facility, she tripped on the door seal and fell, resulting in a fractured right hip that required hospitalization and surgery.
An employee was unloading cattle from a pen to the main drive alley. While the employee was inside the pen, a cow rammed her and knocked her down. The employee sustained a contusion to her right upper torso and three fractured ribs.
An employee was operating a blender in the ground beef department when frozen meat became trapped in the blender. The employee was removing the stuck meat when his right ring finger was caught in the machine, resulting in medical amputation of the finger.
An employee was watching as a frozen pipe was being thawed using heated water from a tank. Hot water was discharged from the top of the tank and burned the employee's upper body and face.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.
An employee was troubleshooting a thigh deboner on a poultry processing line. As he worked to dislodge a thigh bone caught in the blade mechanism, the machine amputated the first and second digits on his left hand. He was hospitalized.
On September 25, 2025, an employee was exiting a yard truck. They slipped and fell approximately 3 feet from the top tread of the steps to the concrete below. The employee sustained a fractured left hip.
An employee was operating a stand-up forklift, picking product for an order. The forklift struck a metal rack and the employee's left arm was caught between the forklift and the rack. He was hospitalized with a fracture to the neck of his radius and an open fracture to the olecranon (elbow).
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.