Triangle Services, Inc.

On or about 6/17/16, an employee was performing mechanical check of a belt loader at a terminal. The belt loader was turned on and put on neutral at the time. The belt loader moved and pinned the employee between two pieces of equipment. He sustained a cut on his leg and required knee surgery.

On 2-2-2015 at about 8:30 a.m., the injured employee was driving a baggage tractor, towing four empty dollies. A forklift was being driven forward with cargo; the operator could not see the travel path and collided with the tractor. The injured employee experienced internal injuries to the stomach from impact with the tractor wheel. The employee was taken to the hospital and is in stable condition.

An employee was walking back to her workstation. A forklift reversed a short distance, then completed a U-turn and struck her, running over her lower extremities. She was hospitalized with a broken ankle.

An employee was training on a jockey truck. Upon stepping out of the truck, the employee was struck by a rubber tire gantry crane, resulting in amputations of the right leg above the knee and left leg below the knee.

An employee was standing at the rear of a double pallet jack. Another double jack approached, and the employee's lower leg was caught between the two pieces of equipment. He suffered a broken tibia and fibula.

An employee was unloading large material bags on a loading dock. A forklift tine pinned the employee's foot against a pallet, causing the employee to fall and suffer a broken ankle.

An employee was pushing a container when they were struck by a forklift. The employee sustained a left leg fracture.

An employee was operating a tug that had been re-tagged due to faulty brakes. As the employee approached the designated parking area, he slowed the tug using the clutch and then exited the tug. He went to stop the tug from colliding with a concrete wall when his right ankle became caught between the tug and a parking stall barrier. He sustained a fractured ankle and was hospitalized.

An employee had just arrived to work and was driving a tug to the gatehouse. The tug ran over chocks while exiting the inbound area, causing the employee to fall to the ground. He was hospitalized with four fractured ribs.

An employee was unloading shipping containers from an aircraft when they suffered heat exhaustion and were hospitalized.

An employee was manually pulling a container from the aft cargo hold of a wide-body jetliner. Their right little finger got pinned between the container and the edge of the cargo door. The employee's finger was partially amputated.

An employee was offloading an airplane flight. After driving a transporter car to place a pallet on a static rack, he got off the transporter to apply the lock and secure the pallet on the rack. The pallet began to roll off the rack and pinned the employee against the transporter. He suffered a broken right leg.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.