Cooke Aquaculture USA, LLC

An employee was assisting with loading product (sacks of dirt) onto a barge. The sack of dirt swung and pinched the employee between it and other sets of product on the barge. The employee suffered a neck compression injury and was knocked unconscious.

An employee was on a barge adjacent to a lift that was being tested. As the load was lowered, a nylon stiffener broke free from existing structural steel and fell 80 feet, striking the employee in the right forearm. The employee sustained two broken bones in the forearm.

An employee was offloading cargo from the hatch of a motor vessel onto a dock when the cargo (bagged cement) struck the employee and caused them to contact a nearby hatch wall. The employee sustained injuries to their neck, right lower back and right leg.

An employee was walking across the barge when they stepped across a barge gunnel lid that was hidden due to coal spillage. The lid came up and struck the employee, resulting in abdominal bruising.

An employee was climbing up an A-frame ladder to gain overhead access to install ship ventilation equipment. The employee's safety glasses bumped the sprinkler head diffuser, which knocked his glasses off and caused a laceration to his left lower eyelid and an injury to the sclera.

An employee on a boat threw a net into a pond to catch catfish. He was seated in the boat when the boat struck the screen on a drain pipe. This caused the employee to fall into the pond and they were struck by the boat. The employee sustained lacerations to his head and right arm.

An employee was holding a gasket for a pneumatic valve when the valve shut on their left index finger, resulting in an amputation.

The injured employee was holding a tee fitting on a pipe while it was being tightened by another employee using a pipe wrench. The injured employee's left little fingertip and fingernail were caught between the pipe wrench and the tee handle, resulting in amputation.

An employee was walking on the side of a pond and distributing fertilizer when his shirt got caught in the power-take-off (PTO) shaft of a tractor. He was pulled in and sustained severe lacerations to his right arm.

While doing housekeeping in the early morning, an employee tripped on an HDPE pipe and fell, breaking his ankle.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.