Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Republic Services, 916 Tonsor Drive, ALTON, ILLINOIS 62002
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was guiding a winch cable when they were caught between the cable and a hydraulic cylinder, resulting in amputation of two fingers on the left hand.
AmputationFinger(s), fingernail(s), n.e.c.Truck-motorized freight hauling and utility, unspecified
On June 24, 2025, at 3:25 p.m., an employee had just finished dumping his truck at the recycling facility when they took a break in their truck. They began to experience signs of heat-related illness and left the cab of the truck before temporarily losing consciousness and collapsing. The employee was hospitalized due to dehydration, heat exhaustion, and acute kidney distress.
An employee was servicing the compactor. They were reconnecting the turnbuckle on a receiver box when the turnbuckle slipped and fell, crushing the employee's left middle fingertip. The employee was hospitalized for surgery.
An employee was tarping and strapping down a garbage container when they slipped on broken glass on the floor and fell. The employee sustained a dislocated shoulder and a brain bleed.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 562212)
A driver had backed up a rear load truck to a dumpster. The winch cable was bound, and another employee went to use the controls to put slack in the line. The cable tightened instead of loosening while the driver was holding it, and it caught his hand against the truck and crushed his thumb. The thumb was fractured and lacerated; he was hospitalized, requiring surgery. The incident took place during a training activity.
An employee was pulling into a customer's parking lot to pick up a roll-off container when the vehicle ran over the median curb. The vehicle then veered to the left, striking the side curb and the retaining wall. The employee sustained injuries to his neck and spine, as well as a damaged artery, a head laceration, and fractured ribs.
An employee was replacing the bracing arm of a baler. The replacement part (weighing an estimated 500 pounds) was moved into place using a truck-mounted crane with a lifting strap attached to the designated pick point. The employee then used his right hand to stabilize/align the part. The part shifted, crushing his right index finger against the mounting pin hole. The employee's finger was amputated above the first knuckle.
An employee was moving a mower with a tractor bucket when the bucket slipped and struck another employee on the hand. The injured employee sustained a partial amputation of their left little finger.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.