Injured by slipping or swinging object held by injured worker · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Evergy, 183rd and Noland, OVERLAND PARK, KANSAS 66013
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was using a drill with a ground rod attached to wind up a line to pull a flat mule line from transformer to transformer. His left little finger became wrapped in the line and was partially amputated.
Employees were setting a pole along a county road to replace a storm-damaged pole. They were positioning the new pole in the hole and were canting the new pole using the pole chain. The pole shifted and dropped in the hole, causing the chain to roll over an employee's right index finger. The chain caught their finger against the pole and resulted in a fingertip amputation without bone loss.
An employee was utilizing an aerial bucket to repair the service drop at a residential home. The truck that the arial bucket is attached to was parked on a slope and began to move. The employee was ejected from the bucket and landed on the ground, sustaining two back fractures.
An employee was carrying out a meter test on the side of a pad-mounted transformer. An arc flash burned the employee's face and hands. The employee was hospitalized.
An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.
An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.
An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.
More severe injuries in this industry (NAICS 221122)
An employee was setting up communication equipment for a meeting. They were walking and tripped over a speaker on the ground. The employee sustained a leg injury.
An employee (a lineman) was working to restore power by installing a hand line when he contacted a high-voltage device (7,200 volts), resulting in electrical burns to his upper body and hands.
A chain sling failed while a utility pole was being removed. A chain link struck an employee who was operating a front-end loader, puncturing the employee's chest.
An employee was working with an underground crew to troubleshoot a BUD failure. The employee was removing a fuse from the fuse holder when the fuse blew on the riser and an arc flash occurred. The employee was hospitalized with burns to his face, nose, lips, and neck.
An employee was connecting two wires when his rubber insulated gloves failed and he suffered an electric shock to his right hand, resulting in an electrical burn.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.