105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

LYCON, INC.

Struck by discharged or flying object, unspecified · Fractures

Federal OSHA recorded a severe workplace injury at LYCON, INC., N2846 17th Drive, WAUTOMA, WISCONSIN 54982 on — Fractures, affecting the skull.

After reassembly work on a ready-mix truck, an employee turned the truck on to check for leaks. The employee was standing on the truck platform, about 3 feet off the ground, when he heard an air leak. As he was turning off the truck, a flying bolt from the plate assembly struck his forehead and broke his skull. He was hospitalized.

Hospitalized Skull Nails, brads, tacks, nuts, bolts, washers

Lycon, Inc.

An employee was washing the chutes of a concrete mixer truck. When he went to move one of the chutes, he slipped in the mud, twisting his back. The employee sustained a strained back.

LYCON, INC.

While exiting a ready-mix truck cab, an employee fell onto the truck platform 2.5 to 3 feet below. He suffered broken ribs on the left side.

View LYCON, INC.'s full OSHA safety record →

HT Energy LLC

An employee was running pipe into a hole on a rig floor. He was still running the other joint into the hole when the laydown machine shot the joint of pipe. The pipe hit the employee in the jaw and he fell backward, suffering a fractured cheekbone.

84 Lumber

An employee was in the yard area on a forklift pulling lumber. Inclement weather began and the employee stopped the forklift and was walking to a safe location when they were struck by flying debris from the high winds or tornado. The employee sustained a leg fracture.

Western States Cat

An employee was working on the parking brake for a piece of equipment when the 60-pound tension plate on the parking break released, striking the employee and causing him to stumble backward and fall. The employee suffered a broken leg that required hospitalization.

Cranesville Block Co. Inc.

An employee was walking through the garage and stepped on a mechanic's creeper. His feet went out from under him and he fell, sustaining a fractured right femur.

Dickinson Ready Mix Co.

An employee was exiting a loader and coming down the ladder. His hand slipped off the railing and he fell backward onto sandy ground, landing on his side. The employee was hospitalized with a fractured pelvis and a rotator cuff tear.

MMC Materials, Inc.

A concrete mixer truck driver was walking up the stairs of the slump rack. They fell from the slump rack platform and landed on the ground in the wash-out area. The employee sustained fractures to their left scapula and lower back vertebrae.

Rapid Redi-Mix LLC.

An employee backed their concrete truck into place to begin unloading it into a concrete pump unit. He exited the vehicle, and went to the rear to unload. When he began unloading, the truck rolled backward and pinned him against the pump unit. The employee sustained fractures to their pelvis, both femurs, both tibias and fibulas, and their left ankle.

Van Eaton Ready Mix, Inc.

A mechanic was changing out an air spring on a concrete mixer truck cab. The air spring was receiving higher air pressure than it was designed to use, because of a faulty level check valve. This increased pressure caused the air spring to burst. Its top portion separated and struck the employee's left forearm, causing a laceration and fracture. The employee was hospitalized, requiring surgery.

RG Professional Carpenter, Inc.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

General Thermodynamics, Inc.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

Sargento Foods Inc

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

Asher Enterprises, Inc.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

Consolidated Electrical Distributors Inc.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.