M1 Support Services, L.P.

An employee was working near an aircraft while a wasp was flying near the employee. As he was walking backward away from the wasp, the employee tripped and fell to the concrete floor, resulting in a left elbow fracture.

An employee was removing a wheel from a car when the car fell from the lift. The employee suffered a left middle finger amputation.

An employee was repairing the right rear tire of a tractor in a customer's yard. While removing the cribbing, the tractor slipped and came down on him. The tire was not yet inflated and the employee was pinned by the tractor. The employee sustained crush injuries to the hip, pelvis, and tailbone including several fractures to the pelvis.

An employee was working underneath a vehicle that was suspended on two jack stands when the vehicle frame broke. The vehicle fell onto the employee, resulting in a back fracture, rib fractures, and a punctured lung.

On June 17, 2023, an employee was checking a tire for leak. As he released the air brake, the semi-truck fell from the jack onto the employee's right arm and rolled forward. The employee sustained an arm injury.

A forklift was unloading a pallet jack from a rental truck when the pallet jack fell off the raised forks and struck an employee as she was working to steady the load. She sustained a right thigh fracture along with scrapes and bruises.

Two employees fell from an access bridge while entering an aircraft to perform maintenance. They landed on the ground about 20 feet below, where one of them lost consciousness. One employee sustained a fractured knee and another employee sustained a back strain/sprain. Both employees were hospitalized.

An employee experienced sharp pain in his lower torso area while loading baggage into the front cargo pit of an aircraft. The employee sustained a hernia.

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

On September 11, 2025, an employee was lowering a railing system on an aircraft fueling cart when his gloved right ring finger was caught in the folding railing system, resulting in a fingertip amputation that required hospitalization and surgical reattachment.

An employee was working at ground level when an aviation engine cylinder weighing 30 pounds fell from a seven-foot high shelf and struck the employee on the head. The employee suffered a fractured skull and was hospitalized.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.