Struck by rolling object or equipment being pushed by injured worker · Bruises, contusions
At a glance
Federal OSHA recorded a severe workplace injury
at Quantem Aviation Services, 201 W. Air Cargo Way, MILWAUKEE, WISCONSIN 53207
on — Bruises, contusions, affecting the lower leg(s).
Final narrative
An employee was pulling an aircraft container off a truck and onto a sorting platform when his foot slipped between the container and the rear of the truck. The container rolled into his lower right leg and he was pinned between the platform and the truck, resulting in a contusion to his lower right leg.
An employee was taking a trash cart to a dumpster when one of their fingers was pinched between the trash cart and the dumpster, resulting in a partial amputation.
An employee was pushing flat shopping carts back into the cart tunnel. When unjamming the carts, part of the cart struck the employee's left shin, resulting in a laceration and bleeding. The employee was hospitalized.
An employee was pulling a cart backward in a storage area when his right little finger was pinched between the cart frame and an electrical box mounted to the side of a support column. The employee's right little finger was partially amputated.
An employee was helping to push a welding trailer out of the path of a truck. The trailer then rolled over a half-inch elevation change that rocked the trailer toward an electrical box. The employee's finger was pinched between the welding trailer and electrical box, resulting in a finger amputation approximately 1/2-inch from the end.
An employee was unloading packages from a trailer onto a cart. While moving the cart, it struck the employee's heel causing a tear to their Achilles muscle. The employee required surgery.
More severe injuries in this industry (NAICS 488190)
Two employees fell from an access bridge while entering an aircraft to perform maintenance. They landed on the ground about 20 feet below, where one of them lost consciousness. One employee sustained a fractured knee and another employee sustained a back strain/sprain. Both employees were hospitalized.
An employee experienced sharp pain in his lower torso area while loading baggage into the front cargo pit of an aircraft. The employee sustained a hernia.
The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.
On September 11, 2025, an employee was lowering a railing system on an aircraft fueling cart when his gloved right ring finger was caught in the folding railing system, resulting in a fingertip amputation that required hospitalization and surgical reattachment.
An employee was working at ground level when an aviation engine cylinder weighing 30 pounds fell from a seven-foot high shelf and struck the employee on the head. The employee suffered a fractured skull and was hospitalized.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.