Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Rheem Manufacturing Company, Inc., 2600 GUNTER PARK DR EAST, MONTGOMERY, ALABAMA 36109
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was using a welding machine. As the employee moved the coupler over to the correct location, the projection welder actuated, coming down on their right hand. The employee sustained a right index finger fracture and a partial amputation of the middle finger.
On February 17, 2023, the injured employee was assisting the operator of a projection welder machine as they were welding a coupling onto a hot water tank. The machine actuated, and the injured employee's left index finger became pinched between the head of the projection welder and the tank. The finger was partially amputated.
An employee was walking on a concrete walkway, heading to a designated break area. The employee stumbled on the walkway and fell on their knee, resulting in a fracture of the left lateral tibial plateau.
Two employees were running a test on a prototype tankless water heater that ran on natural gas when the unit started to overheat. The carbon monoxide alarm sounded and the employees evacuated the room, but one employee was exposed to the gas and required hospitalization.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333415)
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was observing expansion rods on a coil expander going into a coil to ensure copper stubs weren't being bent. His left hand was caught between the locking block and locking block clamp on the power press machine, resulting in partial amputation of his left little finger from the distal interphalangeal joint.
An employee was setting up a press brake and rolling over a die when the tip of their left little finger was caught between the horizontal working surface of the press brake and die. The employee sustained partial amputation of their fingertip.
An employee was working to remove an access panel to begin performing maintenance on a machine. The set pins on the bottom of the panel were broken. The bottom kicked out and fell, striking the employee's left foot and resulting in a fracture to the big toe.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.