Fall on same level due to tripping, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Georgia-Pacific Savannah River LLC, 437 Old Augusta Road South, RINCON, GEORGIA 31326
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was using a utility knife to cut a spool roll to get excess paper off the spool. The employee then tripped with the knife in their hand and fell. The utility knife cut through the employee's glove and partially amputated their left middle finger halfway through the nailbed.
An employee was observing contractors lower a 44-by-88-by- 1/4-inch housing lid using chain fall hoist rigging. The lid came to rest on the guides and was not fitting into place. The employee was pointing and his finger was caught between the lid and housing when the guard was pushed into place. The employee's right index fingertip was amputated.
An employee was unclogging a drain line from the tertiary screen in the recycle mill operations section. While lifting the basket out to clean, hot water sprayed through the seams of the filter. The employee sustained thermal burns on the left hand, forearm, and leg as well as the right thigh and foot.
An employee was walking down the hall to retrieve a vacuum when they stumbled and fell to the floor. The employee suffered wrist bruises and a kneecap fracture that required surgery.
An employee was installing a compressor piston. He tripped and fell backward while the piston was in his lap. As he landed, the little finger of his left hand became caught between the piston and compressor piping resulting in a partial amputation of the fingertip. The employee required stitches and the fingertip was reattached.
An employee was doing an oil change. He was walking to get his oil jug when he tripped on an open lift pad, and fell to the ground landing on his right side. The employee sustained a broken right femur and was hospitalized.
More severe injuries in this industry (NAICS 322121)
Tools and parts were being lowered to the ground from an elevated platform in a 5-gallon bucket. The rope being used to lower the bucket failed; the tools and parts fell and lacerated the left forearm and upper left leg of an employee on the ground.
An employee was tracking an infeed belt on a scrap hogger when their right arm was caught between the belt and a roller. The arm was broken and the employee's shoulder was dislocated. The employee was hospitalized.
An employee was working to clear a jam from a paper napkin folder. The ram that advanced the napkins pushed the employee's right arm into the side of the machine, causing several lacerations and a hairline fracture.
An employee was troubleshooting overflowing ink on a printer-slotter machine when their right ring fingertip was caught in a guarded roller, resulting in a partial amputation.
An employee was disconnecting wires in preparation to swap out a refiner motor when they contacted energized equipment and sustained an electrical shock. The employee was hospitalized.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.