Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Ingersoll Rand, Inc, 1302 Goshen Parkway, WEST CHESTER, PENNSYLVANIA 19380
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was using a grooving machine to put a lip on the edge of a pipe. His glove was caught in the machine, which amputated three of his fingers.
An employee was setting up dies on a die casting machine. The machine's ram unexpectedly returned from the down position and caught the tip of the employee's right thumb against a pinch point in the shot sleeve. The employee suffered an open fracture/amputation to the thumb tip. The machine was not locked out at the time.
An employee was servicing a reciprocating air compressor when their left middle finger was caught in a belt motor pulley sheave while manually moving the belt. Approximately 1/4 inch of the employee's left middle fingertip was amputated.
An employee was operating an aluminum trim press. While reaching down to put another part in a bin, their right hand was crushed by the press resulting in a partial amputation of a finger.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333415)
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was observing expansion rods on a coil expander going into a coil to ensure copper stubs weren't being bent. His left hand was caught between the locking block and locking block clamp on the power press machine, resulting in partial amputation of his left little finger from the distal interphalangeal joint.
An employee was setting up a press brake and rolling over a die when the tip of their left little finger was caught between the horizontal working surface of the press brake and die. The employee sustained partial amputation of their fingertip.
An employee was working to remove an access panel to begin performing maintenance on a machine. The set pins on the bottom of the panel were broken. The bottom kicked out and fell, striking the employee's left foot and resulting in a fracture to the big toe.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.